Nissan Rogue makes clicking noise and won’t start – causes and how to fix it

[eac_elementor_tmpl id="5436"]

When your Nissan Rogue emits a clicking noise upon attempting to start the engine, it’s a common problem associated with no-crank starting issues. Fortunately, in most cases, this issue can be resolved with relative ease. Let’s explore the potential causes and effective solutions for addressing the clicking noise and startup problems in your Nissan Rogue.

Table of Contents

Weak Battery

One of the primary culprits behind the clicking noise and failure to start is a weak battery. If you hear clicking sounds coming from the engine compartment when you try to start the vehicle, it suggests that there’s enough charge in the battery to activate the solenoid, resulting in the clicking noise. However, there may not be sufficient power to engage the starter motor and initiate the engine’s turning motion. It’s important to note that even if the electrical accessories in your Rogue work fine, a weak battery can still be the cause.

Additional Symptoms of a Weak Battery:

Flickering dashboard lights
Rapid clicking noise during startup attempts

Testing the Battery

To assess the condition of the 12V battery in your Nissan Rogue, you can employ a multimeter to measure its voltage. A healthy battery should read 12.6 volts or higher when fully charged. However, keep in mind that voltage alone may not provide an accurate representation of the battery’s capacity. Sometimes, even a battery showing a voltage above 12.4 volts may lack the necessary current to crank the engine successfully.

Voltage Drop Test

Another method for evaluating the battery is by conducting a voltage drop test. Measure the battery voltage while attempting to start the engine. If the voltage drops significantly, falling below 10 volts, it indicates that the battery doesn’t possess enough charge to initiate the startup process. This drop can occur due to internal degradation, prolonged vehicle inactivity, or a malfunctioning alternator that fails to recharge the battery effectively.

Solutions for Jump-Starting Your Rogue

To rule out a dead battery, the recommended approach is to jump-start your Nissan Rogue. Follow these steps:

Requirements: Ensure both vehicles have their engines off, and the transmissions are in Park.

Connect the red cable to the positive terminal of the dead battery in your Rogue.
Attach the other end of the red cable to the positive terminal of the donor battery.
Connect the black cable to the negative terminal of the donor battery.
Finally, connect the other end of the black cable to an unpainted metal part of your Rogue’s body or engine.

Safety Warning

Avoid connecting the black cable directly to the negative terminal of your Rogue’s battery, as it can cause sparks and ignite flammable gases emitted by the battery.

Start your Rogue.
Remove the cables in reverse order.

Note: It’s crucial to refrain from running the engine of the donor vehicle during the jump start, as it can potentially damage the alternator or other electrical components. For this reason, it is advisable to keep the engine of the donor vehicle off while jump-starting your Nissan Rogue.

By following these troubleshooting steps and identifying the root cause of the clicking noise and startup issues in your Nissan Rogue, you can effectively resolve the problem and get your vehicle back on the road.

Read More: